Modra LED na 12V autobateriu
Napsal: stř 31. říj 2007, 20:47
Aky odpor mam pouzit pri zapojeni 8 kusov LED diod na autobateriu ??? Mam dat pre kazdu LEDku odpor zvlast ci postaci aj 1 odpor s vyssou wattazou ???
Diskuze o hardware, software a overclockingu
https://forum.pctuning.cz/
Kód: Vybrat vše
Solution 0: 3 x 2 array, 2 extra LEDs
+----|>|----|>|----|>|---/\/\/----+ R = 120 ohms
+----|>|----|>|----|>|---/\/\/----+ R = 120 ohms
+----|>|----|>|----------/\/\/----+ R = 270 ohms
The wizard says: In solution 0:
each 120 ohm resistor dissipates 48 mW
the wizard thinks ¼W resistors are fine for your application
the 270 ohm resistor dissipates 108 mW
the wizard thinks ¼W resistors are fine for your application
together, all resistors dissipate 204 mW
together, the diodes dissipate 528 mW
total power dissipated by the array is 732 mW
the array draws current of 60 mA from the source.
Solution 1: 2 x 4 array uses 8 LEDs exactly
+----|>|----|>|---/\/\/----+ R = 270 ohms
+----|>|----|>|---/\/\/----+ R = 270 ohms
+----|>|----|>|---/\/\/----+ R = 270 ohms
+----|>|----|>|---/\/\/----+ R = 270 ohms
The wizard says: In solution 1:
each 270 ohm resistor dissipates 108 mW
the wizard thinks ¼W resistors are fine for your application
together, all resistors dissipate 432 mW
together, the diodes dissipate 528 mW
total power dissipated by the array is 960 mW
the array draws current of 80 mA from the source.
Já myslím, že ty malý bývají 0,25W. Ty co běžně dostaneš. Nevím jak je to s nějakýma miniaturníma teda.srna píše:tak tak....pulwattovy vzhledem k tomu ze kalkulacka vyhodila 108mW na rezistor, at je tam naka rezerva....ty mrnavy maj 125mW
//Trinom: Ty mrňavý budou v pohodě stačit...