PCTuning fórum

asi pred dvoma dnami..sa my stalo ze my prestali fungovat USB.. a na druhy den my vyhodilo toto popritlacal som kable a bolo OK Obrázek

neviete kde je problem...dal som tam vistu..setko bolo OK..a na druhy den zapnem PC..a zas toto..

Tohle by mohlo pomoct...

Kód: Vybrat vše

I have just finished putting together another PC based around an Asus motherboard and the dreaded error "USB Device Over Current Status Detected" came up.   The problem was resolved by detached all USB connections directly attached to the motherboard and re-installing them one by one. 

The problem turned out to be a lead coming from an add on multi function bay.   It had two USB flying leads, one of which was the standard block with 5 socket holes on one side and four on the other so that it could only be fitted in one way around. 

It was the second one that caused the problem though.   It came as two separate connectors, one with five sockets holes the other with four.   While it was obvious which socket went were, it was no so obvious which way around they should be. 

As soon as I turned the sockets on the flying lead around 180 degrees and re-inserted them again, everything worked just fine.

Popřípadě zkus hledat tady

nerozumiem tomu. co mam stim robyt.. ak vies..tak my napis priblizny postup.. ako to mam napravit

to, co mas na ty fotce hodne zhruba znamena: varovani, USB zarizeni bere moc proudu, prosim odpoj dane USB zarizeni. system se vypne za 14s...

tudiz: odpoj USB brackety a podobny, zkousej jeden po druhym a nakonec na to nejspis asi prijdes

a ten post kterej je jako code: rika ve svy podstate toto: otoc kabel kterym pripojujes USB na desku....

oticil som to o tich 180° .idem zapnut PC..a zacalo sa my dymit z maticnej

PCTuning fórum

Asus M2E-Sli deluxe. chyba

Asus M2E-Sli deluxe. chyba