Stabilita PC = nastaveni v biosu - jak na to??
Napsal: stř 6. úno 2008, 18:23
Cuz lidi potreboval bych poradit v biosu to momentalne mam nastaveno na :
Ai overclock tuner : manual
CPU ratio setting : auto
FSB STRAP to NORTH bridge : auto
FSB frequency : 266
PCIE frequency : auto
DRAM frequency : DDR2-800MHz
DRAM command rate : auto
DRAM Timing kontrol : manual
Timing information: 5-5-5-15-3-42-6-3-3
CAS latency : 5DRAM clocks
RAS to CAS delay : 5DRAM clocks
RAS PRE Time : 5DRAM clocks
RAS ACT Time : 15DRAM clocks
RAS to RAS delay : auto
REF cycle time : auto
write recovery time : auto
write to read delay : auto
read to pre time : auto
DRAM static read control : auto
Transaction booster : auto
CPU voltage : auto
CPU PLL voltage : auto
FSB termination voltage : auto
DRAM voltage :auto
NB voltage : auto
Clock over-charging voltage: auto
Load-line calibration : auto
CPU GTL voltage reference : auto
NB GTL voltage reference: auto
CPU spread spectrum: auto
PCIE spread spectrum : auto
A jedna se mi o to ze, kdyz spustim test v everestu ultimate - test stability systemu, tak pri 100% zatizeni (rovna cara v grafu) mi to kmita docela casto klidne az o 5% dolu.
Takze bych poreboval vedet jak alespon priblizne nastavit ten bios, nejde az tak o OC.
Sestava: ASUS P5K-V,q6600,dobre chlazeny procik max tepl. 47C ,2*1GB Patriot 800MHz DDR2 ELK a 2*512MB ty same,HDD Hitachi 500GB, grafarnu zatim nemam a droj COOLMASTERs 620W .
Bios nejnovejsi. Dik predem za odpoved.
Ai overclock tuner : manual
CPU ratio setting : auto
FSB STRAP to NORTH bridge : auto
FSB frequency : 266
PCIE frequency : auto
DRAM frequency : DDR2-800MHz
DRAM command rate : auto
DRAM Timing kontrol : manual
Timing information: 5-5-5-15-3-42-6-3-3
CAS latency : 5DRAM clocks
RAS to CAS delay : 5DRAM clocks
RAS PRE Time : 5DRAM clocks
RAS ACT Time : 15DRAM clocks
RAS to RAS delay : auto
REF cycle time : auto
write recovery time : auto
write to read delay : auto
read to pre time : auto
DRAM static read control : auto
Transaction booster : auto
CPU voltage : auto
CPU PLL voltage : auto
FSB termination voltage : auto
DRAM voltage :auto
NB voltage : auto
Clock over-charging voltage: auto
Load-line calibration : auto
CPU GTL voltage reference : auto
NB GTL voltage reference: auto
CPU spread spectrum: auto
PCIE spread spectrum : auto
A jedna se mi o to ze, kdyz spustim test v everestu ultimate - test stability systemu, tak pri 100% zatizeni (rovna cara v grafu) mi to kmita docela casto klidne az o 5% dolu.
Takze bych poreboval vedet jak alespon priblizne nastavit ten bios, nejde az tak o OC.
Sestava: ASUS P5K-V,q6600,dobre chlazeny procik max tepl. 47C ,2*1GB Patriot 800MHz DDR2 ELK a 2*512MB ty same,HDD Hitachi 500GB, grafarnu zatim nemam a droj COOLMASTERs 620W .
Bios nejnovejsi. Dik predem za odpoved.
