PCTuning fórum

Chtel sem se zapojit do tohoto projektu, ale misto aby mi to pocitalo GPU, tak vsechnu praci robi CPU (soude podle vytizenosti jader a minimalni teploty GPU)...
Udelal jsem to podle postupu http://support.ati.com/ics/support/defa ... onID=23354

Nevite jak to nastavit, aby to pocitalo pouze pres Atinu? Dik

stiahol a nainstaloval som toto http://www.stanford.edu/group/pandegrou ... ome503.EXE
potom som stiahol toto
http://folding.stanford.edu/release/FAH ... a4-GPU.zip
a pustam to tym exaciom vtom, sice to pocita gpu aj tak to zatazuje cpu na dakych 50-60%

DIk, funguje

Koro píše:sice to pocita gpu aj tak to zatazuje cpu na dakych 50-60%

Taky sem si nejdřív myslel, že počítat bude GPU a CPU nebude dělat nic, jenže GPU client nevyužívá POUZE GPU, ale GPU+CPU.

z F@H-ATI FAQ:

Client looks like it is using lots of CPU time: Graphics drivers must poll the GPU to see if it is done. This will look like a lot of CPU time being used, but nothing is really being done, so one can run other relatively CPU heavy code at the same time. However, we do not recommend running multiple FAH clients, as this can significantly slow down the GPU client. A good rule of thumb: leave at least 25% of the CPU time available for the GPU client.