Jiri Drak píše:Sentenced píše:
Našel jsem ho normalne ve specifikacich, tak asi nejaky kousky udelaly, ja uz si to taky prd pamatuju.
Ale to uz byly FCPGA ne ? Ale pokud tam ma iBX-ko, tak by pres FCPGA --> slot1 redukci nemel byt problem. Ja jedu v praci na iBX Tulene 1.5GHz.
Nejaky kousky byly nejspis i slotový. Ale prechod byl brzkej. Jinak, že je copper znamej prevazne jako socket je jasny.
jinak tady:
In April of 2000, Intel released their Pentium III Coppermine. While Katmai had 512 KB of L2 cache, Coppermine had half that at only 256 KB. But, the cache was located directly on the CPU core rather than on the daughtercard as typified in previous Slot 1 processors. This made the smaller cache an actual non-issue, because performance benefited. Coppermine also took on a 0.18 micron design and the newer Single Edge Contact Cartridge 2 (SECC 2) package. With SECC 2, the surrounding cartridge only covered one side of the package, as opposed to previous slotted processors. What's more, Intel again saw the logic they had when they took Celeron over to Socket 370, so they eventually released versions of Coppermine in socket format. Coppermine also supported the 133 MHz front side bus. Coppermine proved to be a performance chip and it was and still is used by many PCs. Coppermine eventually saw 1+ GHz.
Pro autora threadu: podle toho cos našel bych to videl dost dobre, to je klasickej starej Katmai a ten by mel bezet. Ted jen doufat, ze v tom značkovym PC nebude totalni shit deska.
). 
)
tak: 
ale chtelo by to vic infa o desce, chipsetu a bude jasno. Jinak je hrozný jak človek zapomíná padlý hrdiny 
