PCTuning fórum

Kód: Vybrat vše

10.1. Pump mode power preset
 
If power preset mode is selected, you can manually set the desired rotation speed
of the pump.
 
10.2. Pump mode temperature set point
 
This mode can be used to automatically adjust pump speed depending on the cur-
rent temperature reading of one of the up to nine available temperature sensors.
The desired target temperature can be configured, all other parameters should not
be changed for normal operation.
Please note that pump speed and the resulting changes in flow rate have only a
minor influence on temperatures in a typical water cooling setup. This mode may
therefore not effect the expected results.
 
10.3. Pump mode curve controller
 
This mode can be used to automatically adjust pump speed depending on the cur-
rent temperature reading of one of the up to nine available temperature sensors.
The controller curve can be configured by assigning output values to 16 corre-
sponding temperature values. The output values in percent correlate to the pump
speed range from ca. 2000 to 4800 rpm. So a value of 50 % correlates to a
pump speed of ca. 3400 rpm, a step of 1 % correlates to a speed change of ca.
28 rpm. If the selected speed cannot be attained, the pump controller will use the
highest stable rotation speed instead.
In the aquasuite, controller curves can easily be adjusted using drag & drop and
curves can automatically be generated from start and end points. In the graphical
curve display, the currently displayed area can be changed using the following
methods:
●
Mouse wheel movements will zoom in and out.
●
A double click on an axis will reset zoom level for this axis, a double click
into the diagram will reset both axes.
●
Selecting an area on an axis will zoom this axis to this area, selecting an
area in the diagram will zoom both axes to this area.
●
Mouse movement while right button is pressed will move the displayed area
of the diagram.
 
10.4. Pump mode flow controller
 
This mode can be used to automatically adjust pump speed depending on the cur-
rent flow rate. The desired flow rate can be configured between 50 to 300 liters
per hour.