problém s nvidia-drivers

[honny]

už nevím jak dál...

upgradoval sem jádro (2.6.18-gentoo-r2 => 2.6.19-gentoo-r5), xorg-x11 (na 7.1) a nv drivery (1.0.9746). Nenaběhly Xka s tím, že mám použít legacy drivery a že moje GK je v novejch nepodporovaná. Dobře, zrušil sem je, nahodil legacy a v těch, zcela zjevně, ještě není podpora pro ni. Tak sem zrušil i je, nahodil starý nvidia-drivers (1.0.9631). Reboot a nic. Log Xek končí takhle:

(II) Setting vga for screen 0.
(**) NVIDIA(0): Depth 24, (--) framebuffer bpp 32
(==) NVIDIA(0): RGB weight 888
(==) NVIDIA(0): Default visual is TrueColor
(==) NVIDIA(0): Using gamma correction (1.0, 1.0, 1.0)
(**) NVIDIA(0): Enabling RENDER acceleration
(EE) NVIDIA(0): Failed to initialize the GLX module; please check in your X
(EE) NVIDIA(0): log file that the GLX module has been loaded in your X
(EE) NVIDIA(0): server, and that the module is the NVIDIA GLX module. If
(EE) NVIDIA(0): you continue to encounter problems, Please try
(EE) NVIDIA(0): reinstalling the NVIDIA driver.
(EE) NVIDIA(0): Failed to load the NVIDIA kernel module!
(EE) NVIDIA(0): *** Aborting ***
(II) UnloadModule: "nvidia"
(II) UnloadModule: "ramdac"
(II) UnloadModule: "fb"
(EE) Screen(s) found, but none have a usable configuration.

Fatal server error:
no screens found

modprobe nvidia dělá

Furia honny # modprobe nvidia
FATAL: Error inserting nvidia (/lib/modules/2.6.19-gentoo-r5/video/nvidia.ko): No such device

GK mám

01:06.0 VGA compatible controller: nVidia Corporation NV17GL [Quadro NVS] (rev a3)

což je převlečená GF 4 MX


s Driver "nv" v xorg.conf samozrejmě všechno jede.

Co s tím?

[Carper]

(II) Setting vga for screen 0.
(**) NVIDIA(0): Depth 24, (--) framebuffer bpp 32
(==) NVIDIA(0): RGB weight 888
(==) NVIDIA(0): Default visual is TrueColor
(==) NVIDIA(0): Using gamma correction (1.0, 1.0, 1.0)
(**) NVIDIA(0): Enabling RENDER acceleration
(EE) NVIDIA(0): Failed to initialize the GLX module; please check in your X
(EE) NVIDIA(0): log file that the GLX module has been loaded in your X
(EE) NVIDIA(0): server, and that the module is the NVIDIA GLX module. If
(EE) NVIDIA(0): you continue to encounter problems, Please try
(EE) NVIDIA(0): reinstalling the NVIDIA driver.
(EE) NVIDIA(0): Failed to load the NVIDIA kernel module!
(EE) NVIDIA(0): *** Aborting ***
(II) UnloadModule: "nvidia"
(II) UnloadModule: "ramdac"
(II) UnloadModule: "fb"
(EE) Screen(s) found, but none have a usable configuration.

Fatal server error:
no screens found

Máš v xorg.conf zaplé glx? To je hodně častý důvod.

[honny]

ano...

Section "Module"
Load "glx"
Load "extmod"
Load "xtrap"
Load "record"
Load "dbe"
# Load "dri"
Load "freetype"
Load "type1"
EndSection

--

dmesg píše při modprobe nvidia

bus pci: add driver nvidia
NVRM: The NVIDIA probe routine was not called for 1 device(s).
NVRM: This can occur when a driver such as rivafb, nvidiafb or
NVRM: rivatv was loaded and obtained ownership of the NVIDIA
NVRM: device(s).
NVRM: Try unloading the rivafb, nvidiafb or rivatv kernel module
NVRM: (and/or reconfigure your kernel without rivafb/nvidiafb
NVRM: support), then try loading the NVIDIA kernel module again.
bus pci: remove driver nvidia
NVRM: No NVIDIA graphics adapter probed!

rivafb, nvidiafb ani rivatv nemám...

[honny]

jsem kretén, někde sem měl nvidiafb...

rmmod nvidiafb & modprobe nvidia => jede to.

ale v modules.autoload bylo nvidiafb zakomentovaný...